Zyx-j30 Manual -

: Plug the device into an AC outlet (100-240V). The charger will automatically detect the battery voltage (12V or 24V). Select Mode : Use the "Mode" touch button to cycle through: : For large batteries (max 8A for 12V, 4A for 24V). : Specifically for AGM and Calcium batteries. MOTORCYCLE : For small batteries (max 1.5A charge current).

4. Initial Setup & Configuration

4.1. Powering On

After wiring pins 1 and 2, the J30 LED indicator will show: zyx-j30 manual

4.2 Powering On

• Press and hold the Power button (located on the left panel) for 3 seconds.
• The LED status ring will flash blue twice, then remain solid green when ready.

Internal Access: Do not open the outer casing; there are no user-serviceable parts inside, and doing so will void your warranty. 5. Maintenance and Cleaning : Plug the device into an AC outlet (100-240V)

1. Turn off. Press MODE + ON/OFF simultaneously.
2. Display shows Axx (e.g., A03 = 3 minutes).
3. Press ZERO to cycle (00 = off, 01 = 1 min, 05 = 5 min, 99 = always on).
4. Press ON/OFF to save.

8. Maintenance & Firmware Updates

• Cleaning: Use isopropyl alcohol and a lint-free cloth on the front panel. Do not immerse.
• Firmware: Download zyx-j30_fw_v4.2.bin from the official portal. Update via the USB-C port using ZYX-FlashLoader.

2. First-Time Setup: Step-by-Step from the Manual

Follow these steps exactly as described in Chapter 3 of the standard ZYX-J30 manual: Press and hold the Power button (located on

5. Operating Instructions

1. Connection: Wire the system according to the diagram. Ensure all screw terminals are tightened.
2. Power On: Switch on the power supply. The LED strip may turn on at the last remembered brightness level or at maximum brightness.
3. Adjusting Brightness:

   The is a 12V/24V smart battery charger often sold under brands like ANHTCZYX or E-Fast. There isn't one definitive "article" for it, but its official operational details and safety guidelines are best found in the product's user manual. Key Manual Instructions