Manual Top | Thyssenkrupp Levant Stair Lift Installation
Thyssenkrupp Levant Stair Lift — Installation Manual (Top-Level Overview)
Welcome to the top-level installation guide for the thyssenkrupp Levant stair lift. This concise, user-friendly overview highlights the essential steps, safety checks, and practical tips installers need to set up the Levant quickly, reliably, and with passenger comfort in mind.
The Verdict: If you are a structural engineer or a certified elevator technician, proceed. If you are a homeowner, use this manual to supervise your installer, not to replace one. thyssenkrupp levant stair lift installation manual top
Once the rail is secure, the motorized carriage is slid onto the track. This component houses the drive motor, batteries, and safety sensors. After the carriage is positioned, the seat assembly is bolted on top. The Levant features a swivel seat designed to make getting on and off safer at the top landing. During this phase, technicians must also install the "charging strips" along the rail, which allow the lift to recharge regardless of where it is parked. Safety Testing and Calibration Lift track onto brackets using two people or
ThyssenKrupp (now TK Elevator) Levant is an award-winning stairlift designed specifically for straight staircases : The drive unit (power pack) is brought
Attach the Seat Post: Secure the main load-bearing post to the top of the carriage.
2.3 Installing Track onto Brackets
- Lift track onto brackets using two people or a lifting jack.
- Securing clips (cam-lock type): Rotate to 90°, listen for click, then tighten set screw to 8 Nm.
- Check track level (not required – track follows stair slope) but check no side bow >2mm over 1m.
: The drive unit (power pack) is brought in and slid onto the rail. Power and Batteries