Dimensions: 
US$
Software Dlms Ashly Protea 48 Install Instant
To install and set up the Ashly Protea 4.8SP software (often referred to as DLMS software), you will need the Protea Software Suite. Modern units no longer include a physical CD-ROM, so you must download the installer directly from the Ashly Audio Software Downloads page. Installation Steps
6. Troubleshooting Common Issues
| Issue | Probable Cause | Solution |
| :--- | :--- | :--- |
| Software cannot find device | PC Firewall blocking UDP ports. | Disable firewall or create an Inbound Rule for Protea.exe allowing UDP ports 5000-6000 (verify specific Ashly ports in manual). |
| Connection Timeout | IP Address conflict. | Disconnect the unit from the network, connect directly to PC, and factory reset the network settings. |
| DLMS Settings Not Saving | Write protection enabled. | Check if the unit is in "Lock" mode; unlock via the physical front panel button or software password. | software dlms ashly protea 48 install
Follow the Wizard: Click "Next" through the license agreement and installation path. To install and set up the Ashly Protea 4
2.2 Audio Connections
- Inputs/Outputs: The "48" typically refers to the maximum channel count or 48kHz sample rate architecture depending on the specific sub-model. Connect source inputs (Mic/Line) and destination outputs (Amps/Speakers) via the Euro-block connectors or TRS/XLR interfaces depending on the chassis backplane.
- Phantom Power: If using condenser microphones, ensure the software phantom power switch is enabled after physical connection.
- USB / Serial: Choose the correct COM port and baud rate (default: 38400).
- Ethernet: Enter the IP address of the Protea 48 (default static IP may be 192.168.1.101).
- Configure Device Settings:
- Connect to the Ashly Protea 48:
To install and set up the Ashly Protea 4.8SP software (often referred to as DLMS software), you will need the Protea Software Suite. Modern units no longer include a physical CD-ROM, so you must download the installer directly from the Ashly Audio Software Downloads page. Installation Steps
6. Troubleshooting Common Issues
| Issue | Probable Cause | Solution |
| :--- | :--- | :--- |
| Software cannot find device | PC Firewall blocking UDP ports. | Disable firewall or create an Inbound Rule for Protea.exe allowing UDP ports 5000-6000 (verify specific Ashly ports in manual). |
| Connection Timeout | IP Address conflict. | Disconnect the unit from the network, connect directly to PC, and factory reset the network settings. |
| DLMS Settings Not Saving | Write protection enabled. | Check if the unit is in "Lock" mode; unlock via the physical front panel button or software password. |
Follow the Wizard: Click "Next" through the license agreement and installation path.
2.2 Audio Connections
- Inputs/Outputs: The "48" typically refers to the maximum channel count or 48kHz sample rate architecture depending on the specific sub-model. Connect source inputs (Mic/Line) and destination outputs (Amps/Speakers) via the Euro-block connectors or TRS/XLR interfaces depending on the chassis backplane.
- Phantom Power: If using condenser microphones, ensure the software phantom power switch is enabled after physical connection.
- USB / Serial: Choose the correct COM port and baud rate (default: 38400).
- Ethernet: Enter the IP address of the Protea 48 (default static IP may be 192.168.1.101).
- Configure Device Settings:
- Connect to the Ashly Protea 48:
