Skope Heated Towel Rail Timer Instructions Patched -

To get the most out of your Skope heated towel rail , understanding the timer functionality is key to balancing comfort with energy efficiency. Most Skope models utilize a boost timer programmable controller

  1. Enter Clock Mode: Press and hold the Mode button for approximately 3–5 seconds until the hour digits on the display start flashing.
  2. Adjust the Hour: Use the + or - buttons to set the correct hour. Pay attention to the AM/PM indicator if your model uses a 12-hour clock.
  3. Switch to Minutes: Press the Mode button again. The minute digits will now flash.
  4. Adjust the Minutes: Use the + or - buttons to set the correct minutes.
  5. Confirm: Press the Mode button one final time to lock in the time.

In some regions, Skope rails are paired with external controllers like the Heirloom Timekeeper Plus . These use a single-button system: Heirloom International : Runs for 3 hours once, then stays off. : 5 hours ON / 19 hours OFF daily cycle. : 4 hours ON / 8 hours OFF (twice daily). : 6 hours ON / 6 hours OFF (twice daily). Heirloom International Does your control panel have buttons (+ and -) on the rail itself, or is it an external wall-mounted switch skope heated towel rail timer instructions

For specific wiring diagrams or replacement parts, contact Skope customer support directly with your model number located on the back of the rail’s mounting bracket. To get the most out of your Skope

Use the 'Clock' button to ensure the current day and time are accurate. Programming 'On' Times: Aim for the rail to turn on roughly 30–60 minutes Enter Clock Mode: Press and hold the Mode