Quantum Resonance Magnetic Analyzer 300 Setup - New

To set up your new Quantum Resonance Magnetic Analyzer (QMRA), follow these steps to ensure the software and hardware communicate correctly. 1. Hardware Connections

Disclaimer: The Quantum Resonance Magnetic Analyzer 300 is intended for educational and research purposes on bio-resonance. It is not a FDA-cleared or CE-marked medical device. Always consult a licensed physician for medical diagnoses. quantum resonance magnetic analyzer 300 setup new

Step 2: Hardware Connection

1. Connect the Bio-Sensing Hand Rod to the dedicated port on the rear of the Main Unit. Ensure the connection clicks securely into place.
2. Plug the USB Cable into the Main Unit and an available USB port on your computer.
3. The power indicator LED on the front of the unit should illuminate Blue, indicating standby mode.

Perform Your First Analysis

1. Enter a dummy patient profile: Name → "Test", Gender, Age.
2. Select "Full Body Analysis" (or 300-item scan).
3. Hold the sensor probe with your thumb and index finger on the metal contacts.
4. Click "Start Scan". The analyzer will collect data for 60–120 seconds.
5. Review your first report. Do not worry about "high" or "low" values yet—test consistency first.

Start Testing: Click "Start Test" and have the subject hold the hand sensor in their palm. To set up your new Quantum Resonance Magnetic

Most setup issues happen here. To avoid driver conflicts, follow this sequence: Connect the Bio-Sensing Hand Rod to the dedicated