Mxq Pro 4k Firmware Update Via Usb Verified

MXQ Pro 4K — Firmware Update via USB (Verified)

Warning: Flashing firmware can brick your device if done incorrectly. Follow instructions exactly. Back up any important data and use a stable power source.

Once it reaches 100% with a "Burning successfully" message, click Stop, disconnect the cable, and reboot your TV box. Alternative: Local Update via USB Drive mxq pro 4k firmware update via usb verified

Identify Your Board: Open the TV box by removing the four bottom screws to check the board version (e.g., R329Q V3.1). Installing the wrong firmware can permanently "brick" the device. MXQ Pro 4K — Firmware Update via USB

1. Open the box and short the NAND pins (typically pins 17 and 18 of the flash chip) using tweezers.
2. While shorting, connect the USB cable.
3. USB Burning Tool will detect it as MASKROM (instead of HUB2–1). Release the tweezers and click Start immediately.

Step 2: Find the PCB Version

Printed on the circuit board, look for text like: Open the box and short the NAND pins