Lenel Lnl3300m5 Installation Manual Upd Top !!top!! -

Report: Lenel LNL-3300M5 — Installation Manual (UPD TOP)

Summary

Scalability: Supports a maximum of 32 board addresses and can communicate with other M5/M3000 units via an external RS-485 port. lenel lnl3300m5 installation manual upd top

For the complete official manual (62 pages, including wiring diagrams, mechanical drawings, and OSDP command reference), download from the LenelS2 Partner Portal (Document # LNL-3300-M5-IM-D 2025-A) or contact technical support. Always refer to the latest revision before installation. Report: Lenel LNL-3300M5 — Installation Manual (UPD TOP)

Once the panel reboots (approx. 30 seconds), browse to http://192.168.0.251. Mounting: Use #6 screws; mount on flat, non-conductive

Grounding: Ensure the board is properly grounded to protect against Electrostatic Discharge (ESD) and signal transients. Initial Web Configuration and IP Setup

2. Physical Installation (Top Paper Best Practices)

• Mounting: Use #6 screws; mount on flat, non-conductive surface. Maintain 2" clearance for ventilation.
• Reader Connections:

  Direct Connection: For initial setup, a technician often connects a computer directly to the board’s 10/100 MB Ethernet port using a crossover cable.

  • Place the LNL-3300M5 magnet body against the underside of the door header.
  • Ensure it is set back far enough so the armature (on the door) will engage fully without hitting the door stop.
  • Critical Step: For "deep" installations, verify that the wiring conduit (the wire lead exit point on the magnet) does not interfere with the door movement. On top mounts, wires typically feed through a hole drilled in the header.

  Lenel LNL-3300-M5 Installation Manual – Key Excerpts (Updated)

  Product: LNL-3300-M5 Dual Reader Interface Module (w/ M5 form factor, PoE+)