Hw 130 Motor Control Shield For Arduino Datasheet Repack

The Ultimate Guide to the HW 130 Motor Control Shield for Arduino: A Complete Datasheet & Application Note

Introduction

In the world of DIY electronics and robotics, the ability to control DC motors is fundamental. While an Arduino Uno or Nano can read sensors and blink LEDs, it cannot directly power a motor. The GPIO pins simply do not provide enough current, and the inductive kickback from a motor can destroy the microcontroller. This is where the HW 130 Motor Control Shield enters the scene.

. It is designed to simplify the control of various motor types directly from an Arduino Uno or Mega. 5.imimg.com Key Specifications 2 x L293D motor drivers and 1 x 74HC595 shift register. Output Current: 0.6A per bridge (1.2A peak). Voltage Range: hw 130 motor control shield for arduino datasheet

Overheating: The L293D chips can get hot. If you are drawing close to 600mA continuously, consider sticking a small aluminum heatsink onto the ICs. Conclusion The Ultimate Guide to the HW 130 Motor

3. Pinout and Connections

This shield utilizes specific Arduino pins to control the motors. If you attach the shield, these pins on the Arduino are occupied. This is where the HW 130 Motor Control