Hager Controls Bp 10140 Manual - Top

Overview

• Model: BP 10140
• Manufacturer: Hager
• Type: Manual Control Unit

Mounting: All these units are designed for DIN rail mounting (standard EN 60715) within a distribution box. Wiring: Connect the Neutral wire directly to the load. Connect the Line (Live) wire to the timer input.

2. Safety Instructions

• Isolate power before installing or removing the top cover/accessory.
• Use only with Hager enclosures and certified components.
• Ensure correct gasket positioning to maintain IP rating.
• Tighten screws to 1.2–1.5 Nm – do not overtighten.

Troubleshooting and Setting Up Your Hager BP 10140 (EG103) Digital Timer hager controls bp 10140 manual top

Conclusion

1. Isolate the panel. Lock out/Tag out. Verify dead with a meter.
2. Clean the busbar. The manual specifies "no oxide layer" – use a non-abrasive cloth.
3. Slide the BP 10140 onto the busbar from the front. Ensure the "TOP" arrow points toward the mains source.
4. Tighten the top clamping screws to the specified torque (e.g., 3.0 Nm).
5. Connect the outgoing tails (25mm² to 50mm² cable recommended) to the bottom terminals. Tighten to 2.5 Nm.

6.2 Series Operation for 48V DC

Connect two units in series (+V of unit 1 to -V of unit 2) to achieve 48V DC. Warning: Do not exceed the insulation rating of the unit (typically 60V DC max). Overview