The E07-M1101D is a compact 433MHz wireless module based on the Texas Instruments CC1101 transceiver chip, typically featuring an 8-pin DIP (Dual In-line Package) layout. Pinout Configuration
General Pinout Structure
| Symptom | Likely Cause | Fix |
|-----------------------------|---------------------------------------|--------------------------------------|
| No SPI response (MISO stuck)| NSS not pulled low; BUSY ignored | Assert NSS low; wait for BUSY=0 |
| Module resets randomly | Insufficient 3.3V decoupling | Add 100 µF bulk cap near pin 3 |
| No RF output | Antenna not connected / wrong pinout | Check pin 1 connection; add matching |
| Erratic DIO0 interrupts | Floating interrupt line | Enable internal pull‑down or external 10 kΩ |
| Overheating | 5 V applied to any pin (even briefly) | Replace module; use level shifter | e07-m1101d pinout
| Module Pin | Connect to MCU | Note | |------------|----------------------------------------|-----------------------------| | 3.3V | 3.3 V output (LDO) | Max 3.6 V, never 5 V | | GND (2) | GND | Common ground | | RST (4) | GPIO | Optional – pull-up resistor| | SCK (5) | SPI SCK | | | MISO (6) | SPI MISO | | | MOSI (7) | SPI MOSI | | | NSS (8) | SPI CS (GPIO) | Active low | | BUSY (9) | GPIO (input, interrupt capable) | Mandatory | | DIO0 (10) | GPIO with interrupt | Optional but recommended | | DIO1 (11) | GPIO (or leave NC) | Optional | | NC (12) | No connect (or GND if specified) | | The E07-M1101D is a compact 433MHz wireless module