Clearvue 350 Service Manual Exclusive !new!

Based on the typical naming conventions of Okuma Corporation (the primary manufacturer of the "Clearvue" series), this guide provides a comprehensive overview for technicians and operators using the Okuma ClearVue 350 service documentation.

Exclusive Procedure:

  1. Discharge capacitors – Wait 15 minutes after disconnecting power. Use a 10kΩ resistor across terminals to short residual charge.
  2. Remove impeller – Unlike standard fans, the CV350 impeller is left-hand threaded. Turn clockwise to loosen. Insert two pry bars into the impeller slots simultaneously to prevent rotation.
  3. Extract the motor cartridge – Do not unbolt the motor from its mount. Instead, loosen the four cartridge retainer bolts and slide the entire motor/bearing assembly out via the rear access door.
  4. Bearing removal – Heat the bearing inner race evenly to 200°F (using an induction heater for 20 seconds). The exclusive manual warns: Do not hammer bearings onto the shaft. Thermal expansion is mandatory.
  5. Installation – Apply Loctite 641 to the shaft journal. Slide the new bearing into place while still warm. Allow 1 hour cure time before reassembly.
  6. Alignment – Insert the CV-ALIGN-350 mandrel through the inlet ring. Adjust motor position until the mandrel slides freely. This ensures concentricity within 0.001".

DICOM Conformance: For networking and connectivity setup, refer to the DICOM Conformance Statement for the ClearVue series. clearvue 350 service manual exclusive

Parts List: Over 100 listings for specific component part numbers, including software modules, cables, and mechanical spares. Helpful Resources & Documentation Based on the typical naming conventions of Okuma